The output required by some customers is not large, so for some corporate customers with low output. There are some specific requirements for drum-type slime dryer equipment, mainly due to different requirements for heat carriers. Here, the technicians of Songshan Machinery came up with a method that can properly conduct heat from the inner wall of the drum of the coal slime dryer. So what are the characteristics of this new type of coal slime dryer equipment? First of all, this kind of slime dryer equipment is made of carbon steel, and it is also lined with three-dimensional equipment such as quartz glass tubes. It has resistance coils and heat source edges inside. A conversion rotary machine is generally installed on the top cover of the coal slime dryer equipment. During the operation of the equipment, the water completes its own evaporation from top to bottom, and the undried material particles reach the coal. The mud at the bottom of the dryer is then discharged from the discharger that is sealed. Generally, this kind of equipment has to go through a tilted condenser before it can enter the inside of the sealed equipment box. Finally, it is packaged inside the packaging box. The dust and water that are not captured, as well as the mixed substances of relatively humid air will be It is discharged from the inside of the slime dryer on the other side. After separation by the separator and dust removal by the heated dust collector, the material is finally discharged from the lower end. The wet air, a mixture of water and air, is discharged after passing through the condenser.
Generally, the heat transfer method of this method of coal slime dryer has certain limitations, and it is difficult to achieve the expected target in terms of processing capacity. During the design, certain parameters should be obtained through a model method before it can be developed. .
Article source: b/
Coal slime dryer b/
How to quickly increase the production capacity of coal slime dryer